保定市配电柜厂

1, cabinet (disc) installation: according to the layout of the construction drawings, the distribution cabinet in accordance with the order of one by one in the basic type of steel. A separate cabinet (disk) solution to the side of the counter and verticality adjustment available iron pad, but not more than three, and the welding firm. The level of the cabinet and the deviation of the panel should be adjusted to meet the requirements of the construction specifications.

2、挂墙式的配电箱可采用膨胀螺栓固定在墙上，但空心砖或砌块墙上要预埋燕尾螺栓或采用对拉螺栓进行固定。

2. The wall type distribution box can be fixed on the wall with the expansion bolt, but the hollow brick or the wall of the block should be pre buried or fixed with the pull bolt.

3、安装配电箱应预埋套箱，安装后面板应与墙面平。

3, the installation of the distribution box should be pre buried, and the panel should be flat after the installation.

4、柜（盘）调整结束后，应用螺栓将柜体与基础型钢进行紧固。

4. After the end of the cabinet (plate) adjustment, the application bolt is used to fasten the cabinet and the basic steel.

5、柜（盘）接地：每台柜（盘）单独与基础型钢连接，可采用铜线将柜内PE排与接地螺栓可靠联结，并必须加弹簧垫圈进行防松处理。每扇柜门应分别用铜编织线与PE排可靠联结。

5, cabinet (tray) grounding: each cabinet (disk) is connected to the basic steel separately, and copper wire can be used to connect the PE rows and the grounding bolts in the cabinet, and the spring washers must be used for loosening prevention. Each cabinet door should be connected with the PE row with copper braiding line respectively.

6、柜（盘）顶与母线进行连接，注意应采用母线配套扳手按照要求进行紧固，接触面应涂中性凡士林。柜间母排连接时应注意母排是否距离其他器件或壳体太近，并注意相位正确。

6, the cabinet (disc) top and the busbar connection, pay attention to the busbar supporting wrench should be fastened according to the requirements, contact surface should be coated with neutral Vaseline. Cabinet bus connection should pay attention to whether the bus from other devices or shell too close, and pay attention to the correct phase.